[Gagi2]

hi&hello...
for example in the cod2/cod4 configuration tab are just only a few lines available...
in an original cod2/cod4 .cfg are much more...
so what to do...
insert the original.cfg in the startupparameter and configure with the cfg (and forget about the gc properties?)
or add all the missing lines in the properties tab (and also in the configuration file with variables...) this could take a while...

and for all subdomains you have to doit again and again and again...

is there any other way to get ALL cfg lines into gc?

[adbot]

[Kybber]

Personally I tend to add the individual config lines as properties
whenever I see a need to be able to easily modify them for
individual servers. Some games have so many config options
that you are never going to use half of them, so why spend time
on creating properties that will only make the config panel messy?

[Gagi2]

sry but my question was not IF i should add them...
the question is HOW can i add MORE THAN ONE at the same time...

in the properties tab is an option View Raw Options where you can add all the needed lines for a property at one time...
something like this also for all properties would do the job i guess...